WORK AREA

3 axis table: 105″ long 49.5″* wide 11″ stroke
Turning center: 94.5″ long 10″ diameter 2.1 degree maximum angle
Joinery Table: 7.25″ long 20″ wide 46″ deep**

*When the table is expanded over the turning center.
**This is a reference to the length of the part you are able to put in the joinery table from floor to cutting area mounted vertically.

FRAME

Welded steel frame
20 mm linear bearings and shafts
X axis and Y axis rack and pinion drive
Z axis precision ball screw drive
A Axis quiet timing belt drive
B Axis Acme screw drive (manual adjust)

DRIVE SYSTEM

Powerful NEMA 34 stepper drives & motors
The Drive systems include a rack & pinion for the X&Y axis, a trapezoidal screw and ceramic nut on the Z-axis and the A-axis is belt driven.

FEED RATES

X axis = 600 inches per minute
Y axis = 600 inches per minute
Z axis – 200 inches per minute
A axis – 300 RPM

SPINDLE

3 HP liquid cooled manual tool change
ER 20 collet and nut. The spindle is rated at 12,000 to 24,000 RPM.
– ER20 0.5″ collet included
– Coolant: 4.5 gallons of 50-50 antifreeze concentrate. Distilled water must be used if not using premixed.

POWER REQUIREMENTS

220 VAC single phase with 20 amp service

DUST MANIFOLD

4″ duct port, we recommend a 6″ dust conduit and 1500 CFM dust collection to the machine.

FOOTPRINT

Machine footprint – 120″ x 69″

.