Adirondack Chair



This Adirondack chair was built using square edge capped Trex from Home Depot.  It will take 3  of the 96 inch lengths to create this chair.


6 of the 3/8 inch  lag bolts 2 1/2 inches long were used to bolt the chair legs together.

1 1/2 inch  decking screws were used to screw the slats on the seat and chair back.

Category: Tag:


19 inch seat slats Counter Sink holes.dxf
Arm Supports.dxf
Back Slats.dxf
Decorative edge and back support – Make 1.dxf
Left Arm Rest.dxf
Left Leg.dxf
Right Arm Rest with cup hole.dxf
Right Arm Rest.dxf
Right Leg.dxf
Vertical back Support – Make 1.dxf
Vertical Leg Left – Make 1.dxf
Vertical Leg Right – Make 1.dxf